Athena GET 2ND INJ. KIT Installationsanleitungen Seite 5

2ND INJECTOR KIT INSTALLATION
1.
Re-install the manifold now equipped with GET 2nd
injector in the rear subframe.
2.
Re-install the rear subframe.
3.
Connect the end of
hose "A" to the fuel
pump.
4.
Connect the hose
"B" to the OEM injector.
5.
Re-connect the electrical wirings disconnected in the
preparatory steps and reinstall the breather tube.
6.
Install GET ECU. Check the specific GET ECU manual to
install the unit properly.
EN
A
To the fuel pump
B
To OEM injector
8
7.
Remove the protective
cap from the "INJ2"
GET ECU connector and
plug it into the female
second injector harness
connector.
8.
Plug the male
connector of the second
injector harness into
the second injector.
9.
Re-install the exhaust pipes, the fuel tank, plastic and
the seat.
9
Second
GET
injector
harness ECU
EN