Athena GET 2ND INJ. KIT Installationsanleitungen Seite 4

2.
Pull the second
injector harness out
from the manifold,
passing it through the
Ø 11 mm / 0.43" hole
milled on the manifold
(see C. Preparatory Steps
/ "Manifold", Step 3). The
harness must stick out
from the manifold about
280 mm / 11.02". Pay
attention to the injector
cable rubber grommet: it
must be properly fitted on
the manifold surface.
3.
Pass GET fuel hose
through the Ø 17 mm
/ 0.67" hole milled on
the manifold (see C.
Preparatory Steps /
"Manifold", Step 3). The
fuel hose must stick out
from the manifold about
430 mm / 16.39".
EN
2nd
injector
harness
Outside
Inside
GET
Outside
fuel hose
Inside
6
4.
Connect the end of
GET fuel hose inside the
manifold to GET fuel rail
using one of the hose
clamps supplied.
5.
Insert the two screws provided into the two Ø5 mm
/ 0.20" holes milled previously. We suggest temporarily
covering the screws with a piece of tape to ease the next
steps because the manifold will be turned upside down.
6.
Insert the provided washers over the Ø5 mm / 0.20"
screws' threads.
7.
Fix the injector
bracket with the
provided bolts.
8.
Remove the tape and check that the injector is properly
installed.
ATTENTION: THE FUEL HOSE MUST NOT OBSTRUCT
THE AIR INTAKE FLOW.
7
Outside
Inside
Outside
Inside
EN