Urban Arrow Family Gebrauchsanweisung Seite 31

2. Tilt the top part of the display towards the magnetic holder
until the display is firmly fixed in the holder.
Image 16 : Inserting the display
Removing the Kiox display from your bike is done as follows:
1. Hold the display by the top end and pull the top end towards
you until is disengages from the magnetic holder 47.
2
If the display is removed from the holder, all values for the
functions are saved and can still be scrolled through.
Securing the Kiox display against removal is done as follows:
2
You need a locking screw (M3 screw, 6mm long) and a Ph-0
screwdriver.
1. Place the display in the display holder 46.
2. Rotate the display holder forward till you can easily reach the
bottom part of the holder.
User manual
3. Screw the locking screw into the thread at 46.
4. Rotate the display holder backwards to the original position.
There are two ways to supply energy to the display:
1. Energy supply by the battery of the e-bike:
If the display is in the holder 46, a sufficiently charged battery
is inserted in the e-bike and the e-bike is turned on, then the
onboard computer is powered by the battery of the e-bike.
2. Energy supply by the internal battery of the display:
If the display is removed from the holder 46, the energy is
supplied via an internal battery.
2
If the display battery's charge is running low, a warning
message appears on the display.
Charging the internal battery of the Kiox display is done as follows:
1. Insert the e-bike battery 58 in the battery cradle (see
paragraph 5.6.2).
2. Put the display in the holder 46.
3. Press the on/off button 57 of the e-bike battery to switch on
the e-bike battery.
Tip You can also charge the display via the USB port 80 (see
paragraph 5.10).
4. Press the on/off button 82 of the display to switch on the
display. The internal battery of the display will be charged
now.
Tip If no power is drawn from the e-bike for about 10 minutes
and no button is pressed on the display, the e-bike and
EN
29