26 6.5 Resetting Error Code Indications; 27 7 After Biking - Urban Arrow Family Gebrauchsanweisung

6.5 Resetting error code indications
The components of the e-bike are continuously and automatically
monitored. If an error is detected, the corresponding error code will
appear on the Kiox display and the Purion display.
2
Depending on the type of error, the electrical drive unit may
automatically shut down. In this case cycling is possible, but
there will be no pedalling assistance while functioning in this
error mode. Take your e-bike to your Urban Arrow dealer to
have it repaired as soon as possible.
Resetting error code indications on the display is done as follows:
1. Press any button on the Kiox display 41 or the Purion display
120 to return to the standard indication.
Depending on the error code the indication will appear on the
display again after the e-bike has been switched off and on.
44 Urban Arrow Family
7 After biking
7.1 Locks
Your e-bike is provided with two locks, one lock on the rear frame
and one lock on the battery. These two locks share the same key.
Lock the bike, using the wheel lock and preferably an additional lock
to secure the e-bike to a static object. This will reduce the chance of
theft.
2
Your lock and set of keys come with a Yourplus code card.
Keep this card for reference. In case of loss of the keys, check
the Abus website (www.abus.com) for information on how to
order a new key. You can also contact your dealer.
Closing the ring lock is done as follows:
1. Put the e-bike on the kickstand (see paragraph 5.8). This will
prevent damage to the spokes when closing the ring lock.
2. Rotate the key 54 20 to 30 degrees clockwise (not a full turn)
and hold it in this position (see image 28).
3. Simultaneously push down the lever on the opposite side
of the lock till the pin snaps into its end position. The key is
released (see image 29).
Tip If the pin hits a spoke, rotate the wheel slightly.
4. Take out the key from of the lock (and store it in a safe place).