Operation - Cameo OPUS W5 Bedienungsanleitung

11
NOTE
As soon as the spotlight is connected correctly to the power, "Software Update
Please Wait..." and the Cameo logo with information on the device model will
display while the device starts up and the motor resets. The spotlight is ready
after this process, and the operating mode that was selected will activate.
The spotlight can be operated using the touch-sensitive control fields next
to the display, or the pressure-sensitive display (can be used with gloves)
itself can be used to access all menu options and intuitively modify settings
as desired. Information on which control element on the display and which
control field next to the display have the same functionality can be found in the
adjacent table.
The following describes how to operate the device using the control fields next
to the display.
MAIN DISPLAY
The upper line of the display shows whether and which control signal is present on the device, the
line below shows the currently active control mode (DMX Standard / Extended, Static, Auto, Slave),
and well visible in the middle is the DMX start address or the corresponding operating mode (e.g.
DMX start address 001). As soon as the control signal is interrupted, the characters on the display
will begin to flash and "None" will display behind "Signal" on the upper line (no signal). When the
control signal is again present, the screen will switch back to the main display. The display can
be rotated by 180° by pressing the touch-sensitive
180°, press the control key to return the display to its standard position. The display can also
be rotated 180° by pressing the "roof" symbol on the pressure-sensitive display.
PAN LOCK
11
Mechanical locking device used to prevent the rotation of
the head in the horizontal direction during transport. Dis-
connect the unit from the mains, move the head parallel
12
to the base (4 possible positions) and push the locking
lever in the direction of the pan rotation axis to lock it in
position. Unlock the device before startup.
TILT LOCK
12
Mechanical locking device used to prevent rotation of the
head in the vertical direction during transport (7 possible
positions). Disconnect the unit from the mains and slide
the locking lever in the direction of the tilt rotation axis,
moving the head of the unit vertically until one of the 7
locking positions is found and the locking lever engages.
Unlock the device before startup.

OPERATION

control key. If the display is already rotated
Display Bedienfeld
-
+
13