Cameo OPUS W5 Bedienungsanleitung Seite 21

SYSTEM SETTINGS (Settings)
Starting from the main display, press ENTER to go to the main menu. Use the
keys to select the System Settings menu and press ENTER.
Display
512
DMX Fail
Dimmer Curve
LED Frequency
Motor
Movement
Fan
This will take you to the submenu for setting the submenu options, see table (select via
confirm via ENTER, change status via
Settings (bold = factory setting)
Display Display
settings
DMX Fail Operational
status with
DMX signal
fault
Dimmer Selection of
Curve the dimmer
curve
LED Fre- Configuration
quency of LED PWM
frequency
and , confirm via ENTER):
OFF
Reverse
ON
Backlight OFF
ON
Black
Hold
Auto
Linear
Exponential
Logarithmic
S-curve
650 Hz, 1530 Hz,
3600 Hz, 12 kHz, 18.9
kHz, 25 kHz
No rotation of the display
Display is rotated through 180° (e.g. for
overhead installation)
Deactivation of the display lighting after
approx. 30 seconds of inactivity
Display lighting permanently on
Activates blackout
Last command is retained
activates Auto mode
Light intensity increases linearly with DMX
value
Light intensity can be finely adjusted at
lower DMX values and broadly adjusted at
higher DMX values
Light intensity can be broadly adjusted at
lower DMX values and finely adjusted at
higher DMX values
Light intensity can be finely adjusted at
lower and higher DMX values and broadly
adjusted at medium DMX values
and control
and ,
21