Connections, Operating And Display Elements - Cameo OPUS W5 Bedienungsanleitung

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

3
POWER IN
1
TRUE1 TOP compatible power input socket. Operating voltage 100–240 V AC / 50–60 Hz. A suit-
able mains cable with TRUE1 TOP compatible plug is included.
POWER OUT
2
TRUE1 TOP compatible power output socket. Facilitates power supply to other CAMEO lights.
Ensure that the total power consumption of all devices connected to the device does not exceed
the given ampere (A) value.
FUSE
3
Fuse holder for 5 x 20 mm micro fuses. IMPORTANT: Replace the fuse only with a fuse of the
same type and of the same value (see stamp on housing). In the event of repeated fuse failure,
please contact an authorised service centre.
DMX IN
4
Male 3-pin and 5-pin XLR sockets for connection of a DMX control device (e.g. DMX console). Only
use the ports alternatively.
DMX OUT
5
Female 3-pin or 5-pin XLR sockets for sending the DMX control signal. Only use the ports alterna-
tively.
NET IN / OUT
6
RJ45 network connectors for connecting to an Art-Net or sACN network in order to send the
control signal. Use CAT 5e, or better, cables to set up the network.
ANTENNA FOR W-DMX™
7
The antenna for control via W-DMX™ remains in the holder (= operating position) during opera-
tion.
7
2
1
6 4 5
11