Maintaining The Equipment; Carbon Brushes; Storing The Equipment; Electrical Connection - Scheppach HS80 Original Bedienungsanleitung

12. Maintaining the equipment

m WARNING: Prior to any adjustment, maintenance or
service work disconnect the mains power plug!
12.1 General maintenance measures
• Keep protective devices, air vents, suction openings
and the motor housing as free of dust and dirt as
possible. Remove shavings and dust with a vacu-
um cleaner and a brush. In addition, blow it out with
low-pressure compressed air.
• We recommend that you clean the equipment imme-
diately after you use it.
• Clean the equipment regularly with a damp cloth and
some soft soap. Do not use cleaning agents or sol-
vents; these may be aggressive to the plastic parts
in the equipment.
Ensure that no water can get into the interior of the
equipment.
• In order to extend the service life of the tool, oil the
rotary parts once monthly. Do not oil the motor.

12.2 Carbon brushes

• In case of excessive sparking, have the carbon
brushes checked only by an electrical specialist.
IMPORTANT: The carbon brushes must not be re-
placed by anyone but an electrical specialist.
Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consum-
ables.
Wear parts*: carbon brushes, table inlay, push stick,
saw blade
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.

13. Storing the equipment

Store the device and its accessories in a dark, dry and
frostproof place that is inaccessible to children. The
optimum storage temperature is between 5 and 30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust
and moisture.
40 | GB
Store the operating manual with the electrical tool.

14. Electrical connection

The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions. The cus-
tomer's mains connection as well as the exten-
sion cable used must also comply with these reg-
ulations.
Important information
In the event of an overloading the motor will switch it-
self off. After a cool-down period (time varies) the mo-
tor can be switched back on again.
Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
This may have the following causes:
• Passage points, where connection cables are
passed through windows or doors
• Kinks where the connection cable has been improp-
erly fastened or routed
• Places where the connection cables have been cut
due to being driven over
• Insulation damage due to being ripped out of the
wall outlet
• Cracks due to the insulation ageing
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Make sure that the connection cable does
not hang on the power network during the inspection.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables with the marking "H05VV-F".
The printing of the type designation on the connection
cable is mandatory.
If it is necessary to replace the connection cable, this
must be done by the manufacturer or their representa-
tive to avoid safety hazards.
AC motor:
• The mains voltage must be 220-240 V~.
• Extension cables up to 25 m length must have a
cross section of 1.5 mm
Connections and repairs of electrical equipment may
only be carried out by an electrician.
www.scheppach.com
.
2