Introduction; Device Description (Fig. A - Ac); Scope Of Delivery - Scheppach HBS400 Original Bedienungsanleitung

1.

Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope your new tool brings you much enjoyment and
success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regulations
and VDE regulations 0100, DIN 57113 / VDE0113.
We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the de-
vice. The operating instructions are intended to help
the user to become familiar with the machine and take
advantage of its application possibilities in accordance
with the recommendations. The operating instructions
contain important information on how to operate the
machine safely, professionally and economically, how
to avoid danger, costly repairs, reduce downtimes and
how to increase reliability and service life of the ma-
chine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in your
country. Keep the operating instructions package with
the machine at all times and store it in a plastic cover
to protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
carefully follow its information. The machine can only
be operated by persons who were instructed concern-
ing the operation of the machine and who are informed
about the associated dangers.
26 | GB
The minimum age requirement must be complied with.
In addition to the safety requirements in these oper-
ating instructions and your country's applicable regu-
lations, you should observe the generally recognized
technical rules concerning the operation of woodwork-
ing machines.
We cannot accept any liability for damage or accidents
which arise due to a failure to follow these instructions
and the safety instructions.

2. Device description (Fig. A - AC)

1. Case door
2. Door lock
3. Saw blade safety device
4. Saw blade guidance
5. Longitudinal limit stop
6. Table width enlargement
7. Tabletop
8. Clamping lever
9. Frame
10. On/Off switch
11. Handle for saw blade tensioning
12. Handle for belt tensioning
13. Adjustment handle for sawblade guard
14. Mitre gauge (not shown / optional accessory)
15. Underframe

3. Scope of delivery

• Bandsaw
• Saw table
• Retainer plate
• Rail with scale
• Push stick
• Guide rail for lengthwise aligning stop
• Longitudinal limit stop
• Allen key
• Screwdriver
• Open-ended spanner (2x)
• Stand feet (4x) (a)
• Cross member, top (2x) (d)
• Longitudinal member, (2x) (e)
• Cross member, bottom (2x) (b)
• Longitudinal member, bottom (2x) (c)
• Rubber foot (4x) (f)
• Wheel set (g)
• Table width enlargement with guide rail for length-
wise aligning stop
• Fastening materials
• Original operating instructions
www.scheppach.com