General Description; Description Of The Equipment - Cebora 334 Betriebsanleitung

2

GENERAL DESCRIPTION

This equipment is a direct current continuous power source designed for plasma arc cutting of electro-conducting
materials (metals and alloys). Along with the torch is a single-gas plasma cutting system (air or nitrogen), completely
managed by a microprocessor , capable of delivering a maximum current of 70 A @ X 60 %(art.334) , 110 A @ X 50
%(art.336), 130 A @ X 50 %(art.337).
All process parameters ( material, gas and current ) are selectable from the display and, according to their choice , the
optimal flow of gas is automatically indicated .
Different sets of consumables are available as a function of cutting current, calibrated and tested for maximum cutting
quality .
2�1

Description of the equipment

(Fig. 1 and Fig. 1/A)
A) Power switch
B) Mains power switch
C) Compressed air fitting (1/4" female gas thread)
D) Pressure gas regulation knob
E) Water trap
F) Interface connector (on request)
G) Grounding clamp
H) Cutting parameters selection and regulation knob
J) Fixed torch fitting
K) Torch connection protection
M) Mobile torch fitting
N) Display showing cutting parameters and other issue
27