Cebora 334 Betriebsanleitung Seite 25

IMPORTANT: BEFORE USING THIS DEVICE, READ THIS MANUAL CAREFULLY AND MAKE SURE YOU
UNDERSTAND ITS CONTENTS�
IMPORTANT: Before reading the following instruction manual, read the instructions in General Warnings
manual 3301151 carefully and make sure you understand them�
Copyright
The copyright of these operating instructions is owned by the manufacturer� The text and illustrations
correspond to the technical specifications of the device at the time of printing and are subject to change.
No part of this publication may be reproduced, stored in a filing system or transmitted to third parties in any
form or by any means, without the manufacturer's prior written authorisation� We are always grateful to be
informed of any errors and suggestions for improving the operating instructions.
Always keep this manual at the place where the device is used.
The equipment can only be used for welding or cutting operations. Do not use this device to charge batteries,
defrost pipes or start engines�
Only expert staff can install, operate, maintain and repair this device. An expert staff member means someone
who can judge the work assigned to them and recognise possible risks based on their vocational training,
knowledge and experience�
Any use that differs from what is expressly indicated and is implemented in different ways or contrary to what
is indicated in this publication amounts to improper use. The manufacturer declines any liability arising from
improper use that may cause accidents to people and possible system malfunctions.
This exclusion of liability is acknowledged upon commissioning of the system by the user.
The Manufacture is unable to monitor compliance with these instructions or device installation, operation and
use, and maintenance conditions and methods.
Inappropriate execution of the installation may lead to material damage and possible personal injury.
Therefore, no liability is assumed for loss, damage or cost arising out of or in any way connected with improper
installation, incorrect operation or inappropriate use and maintenance
It is not permitted to connect two or more power sources in parallel.
If you wish to connect several power sources in parallel, ask for written authorisation from CEBORA which will
determine and authorise procedures and conditions for the required application in compliance with current product
and safety regulations.
Only expert staff can install, operate, maintain and repair this device. An expert staff member means someone who
can judge the work assigned to them and recognise possible risks based on their vocational training, knowledge and
experience.
The installation and management of this device/system must comply with the IEC EN 60974-4 standard.
Liability regarding system operation is expressly limited to the system's function. Further liability of any kind is expressly
excluded. This exclusion of liability is acknowledged upon commissioning of the system by the user.
The Manufacture is unable to monitor compliance with these instructions or device installation, operation and use, and
maintenance conditions and methods provided in the 3301151 manual.
Inappropriate execution of the installation may lead to material damage and consequently to personal injury. Therefore,
no liability is assumed for loss, damage or cost arising out of or in any way connected with improper installation,
incorrect operation or inappropriate use and maintenance.
The welding/cutting power source complies with the regulations set out on the power source technical data plate.
Use of the welding/cutting power source is permitted in automatic or semi-automatic systems.
The system installer is responsible for checking the complete compatibility and correct operation of all components
used in the system.
CEBORA S.p.A. therefore disclaims all liability for malfunctions/damage to its welding/cutting power sources and
other system components due to the installer's failure to perform these checks.
25