Cutting ("Cut" Operating Mode) - Cebora 334 Betriebsanleitung

4�1

Cutting ("CUT" operating mode)

CUT
MILD STEEL
Air 5�5 bar
uminium) and the cutting gas (Airport Nitrogen N2).
Then regulate the cutting current based on:
- type of material chosen and the thickness to be cut
- the gas used
following directions shown in the cutting tables.
While the current is adjusted, display N will show the correct diameter of the nozzle to be used.
Now the correct working pressure can be set by selecting the relevant item and pressing knob H: gas then flows from
the torch.
CUT
MILD STEEL
Air 5�5 bar
Now turn pressure regulator knob D.
The correct working pressure is highlighted by central leds lighting up alongside the set value. If the pressure is too
low or too high, this is highlighted by the left or right led flashing.
Once the pressure is adjusted, lock knob D by pushing it downward.
Display N shows cutting speed based on thickness, for the set material and current.
In particular, when the material is selected and knob H is given a long press, the following figure appears:
Cutting Charts 04
Mild Steel
Thickness =
Vq =
Vp =
- 04 = version of the cutting tables installed
- Vq = quality cutting speed
- Vq = production cutting speed
Press the torch trigger to strike the pilot arc. If you do not start cutting, after 2 seconds the pilot arc goes out; to turn
it back on, press the trigger again.
110 A
Ø 1�50
CP162C
Choose the type of material to be cut (Mild Steel, Stainless Steel or Al-
110 A
Ø 1�50
110 A
12 mm
1,60 m/min
1,75 m/min
37