Technical Specifications; General Description Of The System - Cebora PLASMA PROF 164 HQC Bedienungsanleitung

48
®

2 Technical specifications

2.1 General description of the system

The Plasma Prof 164 HQC, complete with starter unit HV18, gas console PGC1-2, PVC valve
console and torch CP250G, is a mechanized multigas plasma cutting system that is completely
managed by microprocessor, capable of delivering a max current of 120A at 100% duty cycle.
All process parameters (material, gas, thickness and current) may be selected from the gas
console; the optimum gas flow is automatically indicated based on the choices made.
The status of all operating parameters may be easily acquired, via personal computer, through a
RS232 port on the front panel of the power source; this allows a complete overview of the job
situation and can help in the event of any malfunctions.
The machine software can then be updated using the same RS232.
For optimum cutting of any metal material, the system uses different gases, such as: air, nitrogen
N2, oxygen O2, H35 blend (35% hydrogen H2 – 65% argon AR), F5 blend (5% hydrogen H2 –
95% nitrogen N2). Combinations of the latter are automatically suggested based on the material
selected; it is then always possible to use the air-air combination should economic needs prevail
over quality.
Various sets of consumables are available based on the cutting current and gases used, calibrated
and tested to obtain the maximum cutting quality.
3300945-A