Cleaning And Maintenance; Error Messages - CertoClav MultiControl 2 Bedienungsanleitung

Bedienungsanleitung-User Manual_MC2_DE-EN_V7.docx
Temperature OFFSET
• The OFFSET setting allows you to compensate for systematic errors and temperature fluctuations
within the autoclave. These variations can be adjusted directly on the MC controller using the OFFSET
temperature setting to achieve the correct temperature within the autoclave. This options is available
in the settings-menu.
Example:
- Setting MC-Controller:
- Measurement inside the chamber:
- Setting Temp. OFFSET:
- Sterilizationtemp. inside the chamber:

Cleaning and maintenance

If necessary, the controller can be wiped with a damp cloth (not wet!). Maintenance must only be
•
carried out by the manufacturer or an authorized body. No regular maintenance necessary.

Error messages

Error messages are shown on the display as follows:
Message
"Program stopped"
"Power loss"
"Delta-T error"
"Sensor error"
CertoClav Sterilizer GmbH
Peintner Strasse 10
A-4060 Leonding / Austria
www.certoclav.com support@certoclav.com
Possible reason
The program has been
stopped manually by the
user.
Program has been stopped
because of power loss.
The allowed temperature
range of T-1/+2°C has been
exceeded during holding
time.
Temperature sensor
defective.
121°C
119°C
-2°C
121°C
Troubleshooting
Let the autoclave cool down before you start again.
Ensure the fuse holder has been assembled tightly
and that the power cable is mounted correctly. Let
the autoclave cool down before you start it again.
Check temperature sensor cable for cable break.
Check temperature sensor plug for proper
installation.
Check if there is still water in the autoclave
chamber. For long-term cycles, the exhaust steam
spigot must be closed during the holding phase.
Most often this means the sensor is not plugged
into controller properly. Other possible reason:
cable break.
Page 41 of 44