CertoClav MultiControl 2 Bedienungsanleitung Seite 39

Bedienungsanleitung-User Manual_MC2_DE-EN_V7.docx
Program – recurring menu points in program menu:
• Start Starts the selected program
Info
• Displays program steps
New program Overwrites existing program to create a new
•
• Back Back to Programs Menu
Settings
Cycles Number of cycles completed
•
Version Version of firmware
•
• Serial Serial number of the control unit
• Contrast Display contrast. Adjustable from level 1 to level 5
Factory reset
• Resets controller to factory setting
Language Language selector: German / English
•
Back Back to Main Menu
•
Creating a new program
To create a new program, you have to overwrite one of the preset programs! The new specific programs
are shown in the menu with temperature and time (e.g. 125deg16d18h08m). It is not possible to assign
the new program a specific name.
• Use the Λ/V – buttons to go to ‚Programs' and confirm with OK.
• Use the Λ/V – buttons to select the program you want to overwrite and confirm with OK.
• Use the Λ/V – buttons to select ‚New program' and confirm with OK.
CertoClav Sterilizer GmbH
Peintner Strasse 10
A-4060 Leonding / Austria
www.certoclav.com support@certoclav.com
Page 39 of 44