Controller - Usage Of Protocol Printer; Controller - Cleaning And Maintenance - CertoClav MultiControl 2 Bedienungsanleitung

Manual_MC2_DE_EN_V2.docx

Controller - usage of protocol printer

After connecting a CertoClav protocol printer (Art. No. 1300187) the following protocol is
printed:
Header
10 Type of autoclave
15 Program name
30 Cycle number
Program steps
SxxA Heat up
SxxH Hold
SxxC Drying
SxxE End
Footer
40
Control message. Sterilization successful?
Controller – cleaning and maintenance
Cleaning
If necessary, the controller can be wiped with a moist, not wet, cloth.
Maintenance:
Maintenance must only be done by the manufacturer or an authorized body. No regular
maintenance necessary.
CertoClav Sterilizer GmbH
Georg Grinninger-Str. 37
A-4050 Traun / Austria
www.certoclav.com support@certoclav.com
Page 12 of 44