Service; Appliance-Specific Safety Instructions For Belt Sanders; Safety Information For Sanders; Operation - Parkside PBS 900 C3 Originalbetriebsanleitung

g) Use the power tool, accessories and tool
bits, etc. in accordance with these instruc­
tions, taking into account the working condi­
tions and the work to be performed. Use of
the power tool for operations different from
those intended could result in a hazardous
situation .

5 . Service

a) Have your power tool serviced by a qualified
repair person using only identical replace­
ment parts. This will ensure that the safety of
the power tool is maintained .
Appliance-specific safety instructions
for belt sanders
■ Hold the appliance by the insulated handles
since the grinding belt can come into contact
with its own power cable. Damage to a live
wire may make exposed metal parts of the power
tool live and could give the operator an electric
shock .

Safety information for sanders

WARNING!
■ Dusts from materials such as leaded paint,
some types of wood and metal can be harm-
ful to your health .
■ Contact with or inhalation of these dusts can
represent a health hazard for the person
operating the appliance and other people in
the vicinity .
■ Wear safety goggles and a protective dust
mask!
PBS 900 C3

Operation

Tensioning/replacing the abrasive
belt
WARNING! RISK OF INJURY
■ Always remove the power plug from the wall
socket before carrying out any work on the
belt sander .
1 . Loosen the clamping device for the abrasive
belt by swivelling the clamping lever
way out (see fig . A) . The clamping device is
now open and the abrasive belt can be re-
moved .
2 . Now fit a new abrasive belt or swap the belt
to work a different material or to use a different
grain size . IMPORTANT: The direction of the
arrows on the inside of the abrasive belt and
on the appliance housing must match .
3 . Push the clamping lever
position .
Adjusting the abrasive belt:
♦ Pick up the appliance, switch it on and turn it
over . Adjust the belt tracking . To do this, turn
the adjustment screw
abrasive belt is flush with and runs parallel to
the appliance edge (fig . B) . IMPORTANT:
It is important to ensure that the abrasive belt
does not rub against the housing . Check the
belt tracking regularly and adjust it with the
adjusting screw if required
all the
back into its initial
until the edge of the
.
GB │ IE │ 15 ■