Service; Appliance-Specific Safety Instructions For Grinders; Operation; Tensioning/Replacing The Abrasive Belt - Parkside PBSD 600 A1 Originalbetriebsanleitung

5 . Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained .
Appliance-specific safety instructions
for grinders
■ Hold the appliance by the insulated handles
as the abrasive belt
with its own power cable. Damage to a live
wire may make exposed metal parts of the
power tool live and could give the operator an
electric shock .
WARNING!
■ Dusts from materials such as leaded paint,
some types of wood and metal can be harm-
ful to your health .
■ Contact with or inhalation of these dusts can
represent a health hazard for the person
operating the appliance and other people in
the vicinity .
■ Wear safety goggles and a protective dust
mask!
PBSD 600 A1
can come into contact

Operation

Tensioning/replacing the abrasive
belt
WARNING! RISK OF INJURY
■ Always remove the power plug from the wall
socket before carrying out any work on the
belt grinder .
1 . Loosen the clamping device for the abrasive
belt by swivelling the clamping lever
the way out . The abrasive belt
removed .
2 . Now fit a new abrasive belt
belt to work on a different material or to use a
different grain size .
IMPORTANT: The direction of the arrows on
the inside of the abrasive belt
appliance housing must match .
3 . Push the clamping lever
position .
Manually adjusting the abrasive belt
If the belt tracking is not centred when you switch
on the appliance, you may need to manually ad-
just it .
♦ To do this, turn the adjusting screw
front roller until the abrasive belt
centred .
IMPORTANT: It is important to ensure that
the abrasive belt
housing . Check the belt tracking regularly and
adjust it with the adjusting screw if required

Adjusting the additional handle

You can position the additional handle
different positions .
♦ To reposition the additional handle
screw .
♦ Move the additional handle
position .
♦ Retighten the screw
all
can now be
or swap the
and on the
back into its initial
:
on the
is running
does not rub against the
in several
undo the
to the required
.
GB │ IE │ NI │ 5
.
■