Lenze E82ZMFB001 Anleitung Seite 14

All manuals and user guides at all-guides.com
X3 Signal Function (printed
type in bold = Lenze
setting)
8 Analog Act. or setpoint in-
input put
(Use DIP switch and
C0034 to change
the range!)
Output frequency
62 Analog
output
28 Controller inhibit
(CINH)
Activation of JOG Activation of JOG
E1 E1
1) 1)
frequencies f
JOG1 = 20 Hz JOG1
E2 E2
JOG2 = 30 Hz JOG2 = 30 Hz
Digital Digital
JOG3 = 40 Hz
inputs inputs
DC injection brake
E3
(DCB)
C a ge o d ec Change of direc-
E4
tion of rotation i
CW/CCW rotation CW/CCW rotation
Ready for opera-
A1 Digital
tion
output
9 - Internal, stabilized
DC voltage supply
for setpoint poten-
tiometer
20 - Internal DC voltage
supply for control
of digital inputs and
output
59 - DC supply for A1
7 - GND1, reference
potential for analog
signals
39 - GND2, reference
potential for digital
signals
1)
or frequency input 0 ... 10 kHz, configuration under C0425
The terminal assignment of the bus function module (e.g. INTERBUS) can
be obtained from the attached Instructions.
l
I/O function module wiring
Level
0 ... +5 V
0 ... +10 V
-10 V ... +10 V
0 ... +20 mA
+4 ... +20 mA
+4 ... +20 mA
(open-circuit monitored)
0 ... +10V
1 = START
i
JOG1
20 Hz
JOG2
JOG3
1 = DCB active
f i
CW
CCW
0/+20 V at DC internal
0/+24 V at DC external
+5.2 V (ref.: X3/7)
+20 V (ref.: X3/7)
+20 V (internal, bridge to
X3/20)
+24 V (external)
-
-
E1 E2
1 0
0 1
1 1
E4
0
1
- 6 -
Technical data
Resolution: 10 bit
Linearity error: ± 0.5 %
Temperature error:
0.3 % (0 ... +60°C)
Input resistance
Ÿ Voltage signal: > 50 k Ω
Ÿ Current signal: 250 Ω
Resolution: 10 bit
Linearity error: ± 0.5 %
Temperature fault: 0.3 % (0 ...
+60°C)
Load capacity: max. 2 mA
Input resistance: 3.3 k Ω Input resistance: 3.3 k Ω
1 1 = HIGH = HIGH
(+12 ... +30 V) (+12 ... +30 V)
0 = LOW
(0 ... +3 V)
(PLC level, HTL) (PLC level, HTL)
Load capacity:
10 mA
50 mA
Load capacity: max. 10 mA
Max. load capacity
Σ Σ Σ Σ I = 40 mA
isolated to GND2
isolated to GND1
EDK82ZAFB 2.0