Turning On; Setting The Temperature; Adjusting The Radiation Angle; Turning Off - Parkside PKH 2000 B1 Bedienungs- Und Sicherheitshinweise

˜ Turning on
Set the temperature control
heating level switch
Connect the power plug
RCD-protected socket-outlet .
NOTES:
Make sure that the supply voltage of the
socket-outlet meets the requirements described
in the "Technical data" chapter .
Make sure that the power plug
inserted into the socket-outlet .
To turn on the product, turn the heating level
switch clockwise .
4 ] [
Position Meaning
0
Product turned off
Fan operation
no heating power
Low heating level
1100 W
High heating level
2000 W
NOTES:
Heating level switch
Control light on .
2 ] [
Heating level switch
Control light off .
2 ] [
˜ Setting the temperature
To regulate the temperature at high or low
heating level, turn the temperature control
clockwise until it stops .
to and the
3 ] [
to 0 .
[ 4 ]
to an
7 ] [
is fully
7 ] [
set to , or
[ 4 ]
set to 0:
[ 4 ]
3 ] [
As soon as the desired temperature has been
reached, turn the temperature control
counter-clockwise until you hear a clicking
sound .
NOTE: The integrated thermostat
automatically turns the heating function on and
off to keep the temperature at a constant level .
Position Meaning
lowest temperature range
low to medium temperature
range
medium to high temperature
range
highest temperature range
˜ Adjusting the radiation angle
Changing the radiation angle of the air
outlet : Use the knurled screw
[ 5 ]
housing to the desired angle .
NOTE: Do not touch the product with wet
hands or if the product's housing is hot .
:
˜ Turning off
NOTE: If you have used the product at high
or low heating power, let the product run in fan
mode for about 30 seconds . This will prevent
heat build-up in the housing .
Set the temperature control
heating level switch
Disconnect the power plug
outlet .
3 ] [
to turn the
[ 6 ]
to and the
[ 3 ]
to 0 .
4 ] [
from the socket-
7 ] [
GB/IE 29