Herunterladen Inhalt Inhalt Diese Seite drucken

Before The Start Of Operation; Setting Up The Fan Heater; Commissioning; Switching Heat Settings And Fan On/Off - Parkside PKH 3000 A1 Bedienungs- Und Sicherheitshinweise

Vorschau ausblenden Andere Handbücher für PKH 3000 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
Do not operate the fan heater
in the vicinity of open flame.
Do not place the fan heater di-
rectly below or above a wall
socket.
Pull the plug out of the socket
in the event of malfunctions and
during thunderstorms.
Never use the fan heater in the
immediate vicinity of a bath,
shower or swimming pool.
20
GB/IE

Before the Start of Operation

Setting up the Fan Heater

Remove all packaging material and all transport
securing devices from the fan heater.
For safe and error-free operation of the fan heater, the
installation site must meet the following requirements:
– The ground must be firm, flat and level.
– A minimum distance of 30 cm must be kept to
the side, 30 cm to the top, 30 to the rear and
100 cm to the front.
– Do not place the fan heater in a hot, wet or very
humid environment or near flammable material.
– The socket must be easily accessible so that
the mains cable 7 can be easily removed in
case of emergency.
– Temperature range: 0 to +85 °C
– Air humidity (no condensation): 5–75%
Please note: When used for the first time, it may
briefly cause a slight odour.

Commissioning

Switching Heat Settings
and Fan on/off
Make sure the heating level switch 2 is set to 0.
Then connect the heater to a earthed and fused
plug socket protected by a GFCI. Free rotation of
the fan must be ensured.
Now switch on the fan heater by turning the heat-
ing level switch 2 to the desired position. For this:

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis