Connecting The Cylinder Pressure Sensor (Cps) To Regulator - INTERSPIRO Divator HUD Gebrauchsanweisung

4. Wind the cable around the full length of the breathing hose by holding the
cable straight and rotating the breathing hose around the cable.
5. Put 2 or 3 turns of the spiral hose wrap around the breathing hose, close to
the hose end nipple.
6. Put the cable under 2 or 3 turns of the spiral hose wrap.
7. Put the remaining turns of the spiral hose wrap around the breathing hose.
Connecting the Cylinder Pressure Sensor (CPS)
to regulator
The following installation should be performed by a certified service technician.
The Divator HUD (and pressure gauge) must be connected to a high pressure
outlet with a flow restrictor, according to the requirements of EN 250.
Please note that the instruction below is generic, and that it may have to be
adopted for different regulator configurations. (There are Interspiro HUD con-
nection kits available.)
Divator HUD
13