After Use; Charging The Cylinder With Air - INTERSPIRO Spiroscape Bedienungsanleitung

Push both your hands into the opening of the neck seal and pull the hood over
4.
your head; see [figure 3]. Adjust the hood so that it fits comfortably and so that
you can see properly.
NOTE: PERSONS WEARING GLASSES SHOULD PULL THE HOOD ON FORWARDS OVER THE HEAD, STARTING AT THE BACK
OF THE NECK. STRETCH THE NECK SEAL OUT TO CLEAR YOUR GLASSES.
If necessary, adjust the length of the neck strap.
5.
Begin the evacuation and leave the toxic environment immediately. See [figure 4].
6.
4

AFTER USE

Check that the hood and hose has not been damaged. If the hood and hose is
1.
damaged, send it away for servicing or replace damaged parts.
Clean the inside of the visor and the outside of the outer hood with a soft cloth
2.
and mild disinfectant. Then wipe the parts dry with a soft cloth.
5

CHARGING THE CYLINDER WITH AIR

Connect the auto-fill adapter, see [figure 1], to the air supply or compressor via the
1.
charging hose.
NOTE: THE FILL ADAPTER MUST BE SUPPLIED WITH THE FULL CHARGING PRESSURE BEFORE THE SPIROSCAPE IS
CONNECTED.
Break the anti-tamper seal [ref a, figure 5].
2.
Open the Velcro fastener of the bag.
3.
Open the zipper of the bag.
4.
Uncover the cylinder valve knob.
5.
Disconnect the air hose from the cylinder valve by removing the pin [ref b, figure
6.
5]. To avoid losing the pin, refit it to the air hose.
Carefully attach the auto-fill adapter by hand. Turn it clockwise until air can be
7.
heard flowing, then turn it a quarter-turn further.
Charge the cylinder until the gauge shows full. Wait for the cylinder to cool down,
8.
then "top up" the cylinder until the gauge again shows full.
NOTE: IF THE AIR SUPPLY IS ACTIVATED DURING THE CHARGING PROCESS, TURN THE CYLINDER VALVE KNOB COUNTER-
CLOCKWISE UNTIL THE AIR STOPS FLOWING.
Unscrew the auto-fill adapter.
9.
Re-connect the air hose to the cylinder valve with the pin [ref b, figure 5].
10.
NOTE: MAKE SURE THAT THE QUICK-START RING [REF D, FIGURE 5] IS NOT UNDER THE HOSE WHEN YOU RE-CONNECT THE
HOSE.
9