Dell EMC PowerEdge XR11 Installations- Und Servicehandbuch Seite 109

Installing the MIL 901E and MIL 461G rugged kit
Prerequisites
NOTE: The MIL 901E and MIL 461G rugged kits are ordered separately from Dell.
1. Follow the safety guidelines listed in
2. Unpack the 901E and MIL 461G rugged brackets.
3. Remove the front bezel
4. Remove the system cover.
Steps
1. Using a Phillips 2 screwdriver, secure the power supply rugged bracket.
NOTE: The kit consists of screws. Use three screws on the bottom side of the chassis and remaining three screws
above the bracket.
Figure 110. Installing the 901E and MIL 461G power supply rugged bracket
2. Align the left edge of the drive retention bracket to the guide slots on the left side of the drive module. Using a Phillips 2
screwdriver, secure the 901E and MIL 461G drive rugged bracket.
NOTE: To secure the 901E and MIL 461G drive rugged bracket, ensure to use the black screws that are shipped with
the 901E and MIL 461G kit.
Safety instructions.
for Rear Accessed configuration.
Installieren und Entfernen von Systemkomponenten 109