Dell EMC PowerEdge XR11 Installations- Und Servicehandbuch Seite 92

über die Konfiguration von Ersatzteilen finden Sie im Handbuch für Lifecycle Controller unter
idracmanuals.
Power interposer board
This is a service technician replaceable part only.
Removing power interposer board (PIB)
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the PCI air shroud.
4. Remove both PSUs.
5. Disconnect all the cables that are connected to the system board, intrusion switch, Fan1, Fan 2 and Fan 3 from the power
interposer board (PIB).
NOTE: The procedure to remove the power interposer board (PIB) is the same for Rear Accessed and Front Accessed
configurations.
Steps
1. Using a Phillips 2 screwdriver, remove the screws securing the power interposer board to the system.
NOTE: Observe the routing of the cables as you remove them from the system.
2. Lift the PIB away from the system.
Figure 90. Removing the power interposer board
92 Installieren und Entfernen von Systemkomponenten
Safety instructions.
Vor der Arbeit an Komponenten im Inneren Ihres
https://www.dell.com/
Systems.