Dell EMC PowerEdge XR11 Installations- Und Servicehandbuch Seite 101

Figure 98. Installing the status LED control panel for Rear Accessed configuration
4. Align and insert the left ear handle in the slot on the system and tighten the screws using Torx 8 screwdriver.
Figure 99. Installing the left ear handle for Rear Accessed configuration
Next steps
1. Install the expansion card riser
2. Install the processor and heat sink
3. Install the air shrouds.
4. Follow the procedure listed in the
Removing the power button control panel for Rear Accessed
configuration
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the processor air
4. Remove the expansion card riser
1.
module.
After working inside your
Safety instructions.
Vor der Arbeit an Komponenten im Inneren Ihres
shroud.
1.
system.
Systems.
Installieren und Entfernen von Systemkomponenten 101