Dell EMC PowerEdge XR11 Installations- Und Servicehandbuch Seite 73

Removing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
NOTE: The procedure to remove the expansion card risers is the same for Rear Accessed and Front Accessed
configurations.
Steps
1. For riser 1, using the Phillips 2 screwdriver, loosen the blue thumbscrew.
2. Holding the blue touch points, lift the expansion card riser from the riser connector on the system board.
Figure 62. Removing Riser 1
3. For riser 2 and 3, using Phillips 2 loosen the blue thumbscrews. Hold the blue touch points, and lift the expansion card riser
from the riser connector on the system board.
NOTE: Riser 2 and 3 are combined in one expansion card riser.
Safety instructions.
Vor der Arbeit an Komponenten im Inneren Ihres Systems.
Installieren und Entfernen von Systemkomponenten 73