Dell EMC PowerEdge XR11 Installations- Und Servicehandbuch Seite 81

Figure 75. Installing expansion card in Riser 2 and 3
Next steps
1. Follow the procedure listed in
2. Install any device drivers required for the card as described in the documentation for the card.
NOTE: While replacing faulty storage controller or NIC or the GPU card with the same type of card, after you power on the
system, the new card automatically updates to the same firmware and configuration of the faulty one. For more information
about the Part replacement configuration, see the Lifecycle Controler User's Guide at
Optionale BOSS-S1-Karte
Removing the BOSS S1 card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
NOTE: The procedure to remove the BOSS S1 card is the same for Rear Accessed and Front Accessed configurations.
Steps
Holding the blue tag, pull the BOSS S1 card away from the system board connector.
Nach der Arbeit im Inneren des
Safety instructions.
Before working inside your
Systems.
system.
Installieren und Entfernen von Systemkomponenten
https://www.dell.com/idracmanuals
81