Dell EMC PowerEdge XR11 Installations- Und Servicehandbuch Seite 93

Next steps
Replace the power interposer
Installing the power interposer board (PIB)
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
NOTE: The procedure to install the power interposer board (PIB) is the same for Rear Accessed and Front Accessed
configurations.
Steps
1. Align the slots on the PIB with the hook on the system and slide it into place.
2. Using Phillips 2 screwdriver, tighten the screws to secure the PIB to the system.
Figure 91. Installing the power interposer board
3. Reconnect all the required cables.
Next steps
1. Install the PSU.
2. Install the PCI air shroud.
3. Follow the procedure listed in
board.
Safety instructions.
Vor der Arbeit an Komponenten im Inneren Ihres
Nach der Arbeit im Inneren des
Systems.
Systems.
Installieren und Entfernen von Systemkomponenten 93