Dell EMC PowerEdge XR11 Installations- Und Servicehandbuch Seite 95

Next steps
Install the system board.
Installing system board
Prerequisites
NOTE: Before replacing the system board, replace the old iDRAC MAC address label in the Information tag with the iDRAC
MAC address label of the replacement system board.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If you are replacing the system board, remove all the components that are listed in the
NOTE: The procedure to install the system board is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Unpack the new system board assembly.
CAUTION: Heben Sie die Systemplatinenbaugruppe nicht an einem Speichermodul, einem Prozessor oder
anderen Komponenten an.
CAUTION: Take care not to damage the system identification button while placing the system board into the
chassis.
NOTE: Do not remove the processor socket cover until the system board is assembled in the system and ready for
installation of the processor and heat sink module.
2. Holding the system board by the edges, lower the system board it into the system.
3. Align the connectors on the system board with the slots on the rear of the system until the connectors are firmly seated in
the slots.
Figure 93. Installing the system board
4. Using a Phillips 2 screwdriver, tighten the screws sequentially and secure the system board to the chassis.
Safety instructions.
Vor der Arbeit an Komponenten im Inneren Ihres Systems.
Installieren und Entfernen von Systemkomponenten
removing the system board section.
95