Installing The Hob - hanseatic MC-HF662B Gebrauchsanleitung

– The hob must be surrounded by at least
50 mm of worktop on all sides.
– If the hob is separated from the rest of the
mounting cupboard using a horizontal fix-
ing plate, the space between the base of
the appliance and the fixing plate must be
at least 50 mm high.
– If the hob is separated from the rest of the
mounting cupboard using a vertical fixing
plate, the space between the wall and the
fixing plate must be at least 20 mm broad.
– At the back of the fixing plate, a square
opening with a side diameter of at least
80 mm must be cut out.
– If the hob is installed over an oven with
ventilation, the clearance between the
base of the appliance and the cover of the
oven must be at least 50 mm.
– Veneers, plastic coverings and adhesives
used must be heat-resistant up to 100 °C
(100 °C).
Luftauslass
Luftauslass
– The hob must be positioned in such a way
that the air outlet is not compromised.
590 mm
55 mm
52 mm
>50 mm
490 mm
>50 mm
>50 mm
1. If no recess is available, cut a recess into
the worktop: 560 x 490 mm (B x D).
520 mm
>50 mm
560 mm
Installation
2. If a hob was already installed, the recess it
was in must be a maximum of 574x490 mm.
Affix adjustment strips of a maximum of
7 mm to the left and to the right in order to
achieve the breadth of 560 mm.

Installing the hob

1. Take the hob out of the packaging.
2. Remove all protective films and adhesive
tapes.
3. Check whether there is the same clear-
ance to the right and the left within the
recess.
4. Place the hob with the control panel fac-
ing forward in the recess of the worktop
and press it in firmly.
5. Affix the hob with the enclosed retaining
clamps in order to prevent slipping.
Kochfeld
Arbeitsplatte
A
A (thicker worktop)
B (thinner worktop).
Seite EN-23
Kochfeld
Arbeitsplatte
B