Safety Notices; Risks In Handling Household Electrical Appliances - hanseatic MC-IV10241B2CC-A Gebrauchsanleitung

Safety notices

In this chapter, you will fi nd general
safety notices which you must always
observe for your own protection and
that of third parties. Please also ob-
serve the warning notices in the individ-
ual chapters on operation, set-up, etc.
WARNING
Risks in handling household
electrical appliances
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■ Only use the appliance indoors. Do
not use in wet rooms or in the rain.
■ Do not operate or continue to oper-
ate the appliance, if
– it shows visible signs of damage,
for example, the connection cable
is defective;
– starts smoking or there is a burning
smell;
– it makes unusual sounds.
In such cases, switch off/unscrew the
fuse and contact our Service Centre
(see page EN-27).
■ Connection to the mains supply may
only be made by an authorised elec-
trician approved by the local energy
supply company (see "Service" on
page EN-27). Only then will you bene-
fi t from our warranty and a suffi cient
level of safety. Unauthorised persons
may not connect the appliance to the
mains supply. You can endanger your
life and that of subsequent users! This
also applies to disconnection from
For your safety
the power supply and dismantling
the old appliance. The appliance is
designed for alternating current 220-
240 V~ / 380-415 V 3N~ / 50 Hz. The
appliance may be connected only to
a pre-installed mains cable of type
H07RN-F with a conductor cross-sec-
tion of at least 5 × 1.5 mm
rated current of maximum 16 A.
■ Keep the mains plug and mains cord
away from naked fl ames and hot sur-
faces.
■ Do not kink or pinch the mains cable
or lay it over sharp edges.
■ If the mains cable of the appliance is
damaged, it must be replaced by the
manufacturer, through the customer
service department or by a qualifi ed
specialist.
■ Since all poles of the appliance can-
not be disconnected from the mains
via an accessible disconnecting de-
vice, an all-pole disconnecting device
in accordance with overvoltage cate-
gory III must be connected within the
house installation with at least 3 mm
contact clearance; consult a qualified
professional if necessary (see "Ser-
vice" on page EN-27).
■ Before connecting the appliance,
switch off the relevant power circuit
or turn off the relevant fuses. Before
accessing the terminals, all supply cir-
cuits must be switched off.
■ Do not extend or amend the power
cord.
■ Never open the housing.
■ Never repair a defective or suspected
defective appliance yourself. You can
put your own and future users' lives
in danger. Only authorised specialists
Page EN-5
2
and with a