Mounting The Drive Tube; Mounting The Loop Handle - Stihl HLE 71 Gebrauchsanleitung

English
4

Mounting the Drive Tube

2
3
A
► Pull the protective cap off the drive tube.
► Push the drive tube (1) into the motor hous‐
ing (2) as far as the mark (A), turning the drive
tube back and forth at the same time.
► Tighten down the screw (3) in the housing
firmly.
26
5
1
A
► Place the clamp (1) in the loop handle (2) and
place it between the lifting eye (3) and the
handle hose (4) on the shaft (5)
► Position the clamp (6) against the shaft
► Line up the holes
► Insert the screws (7) with washers (8)
► Fit the square nuts (9) and screws
► Align the loop handle (2) and move it to the
most comfortable position
Distance (A) must not be more than 45 cm. Rec‐
ommendation: about 35 cm
► Tighten screws
4 Mounting the Drive Tube

Mounting the Loop Handle

7
8
3
6
9
A
7
8
2
1
9
2
0458-277-9621-B