Cleaning The Mini Turbo Brush; Cleaning The Housing - Royal UP1Light Bedienungsanleitung

6 Maintenance
6.6 Cleaning the mini
turbo brush
35
36
37
a

6.7 Cleaning the housing

40
If the brush roller of the mini turbo brush only rotates
slowly or does not rotate at all, it is blocked by dirt (hair, long
pieces of fluff).
b
In this case, clean the mini turbo brush as follows.
1. Actuate by hand the release catch on the bottom sec-
tion (Fig. 35/a) and pull up the upper section of the mini
turbo brush with the other hand (Fig. 35/b).
a
2. Put the lower section of the mini turbo brush onto a sta-
ble surface as shown (Fig. 36).
3. Remove dirt by hand. If this isn't enough, carefully use
scissors (Fig. 36).
4. Put the upper section into place at the front first so that
the four recesses of the upper section engage with the
b
four tabs of the lower section (Fig. 37/a).
5. Then shut the upper section at the back firmly (Fig. 37/
b). You should feel and hear it click into place.
WARNING:
Danger of injury! Before you clean the appliance, switch
off the appliance and unplug the mains plug,
5.1, "Switch off device and put into idle running mode".
ATTENTION:
Do not use cleaning or scouring agents or alcohol, as
these might damage the appliance's housing.
Clean the outside of the housing using a slightly damp
cloth only.
Chapter