Changing The Motor Protection Filter; Cleaning The Housing - Royal Dirt Devil EQU Bedienungsanleitung

4 Maintenance
4.4 Changing the motor
protection filter
24
25
26

4.5 Cleaning the housing

32
1. Switch off the vacuum cleaner and remove the dust filter
bag as described in
filter bag", steps 1 thru 4.
2. Remove the filter holder with the motor protection filter
(Fig. 24).
3. Remove the motor protection filter from the filter holder
over a dustbin (Fig. 25/A).
If the motor protection filter is slightly dirty:
- Beat the dust out of the motor protection filter over a
dustbin (Fig. 25/B).
If the motor protection filter is very dirty:
- Replace the used motor protection filter by a new one.
If the new motor protection filter is too large, lay the
the old filter onto the new filter mat to be cut. Mark the
contours and cut the new filter down to size with a pair
of scissors.
4. Clean the filter holder.
5. Insert the filter holder complete with filter into its bracket
from above (Fig. 26).
6. Replace the dust filter bag and close the dust
compartment cover. The cover snaps into place
audibly.
WARNING:
Danger of injury! Always switch off the appliance and
disconnect it from the mains before cleaning it
3.3, "Switching off and retracting power cord". Otherwise
the machine might start up and parts of your body, hair or
pieces of clothing might be sucked in.
ATTENTION:
Do not use cleaning or scouring agents or alcohol, as
these might damage the appliance's housing.
Clean the outside of the housing using a slightly damp
cloth only.
Chapter 4.1, "Changing the dust
Chapter