Herunterladen Inhalt Inhalt Diese Seite drucken

Replacing The Hea Filter; Use - Parkside PAFS 550 A1 Originalbetriebsanleitung

Airless-farbsprühsystem
Vorschau ausblenden Andere Handbücher für PAFS 550 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 23

Replacing the HEA filter

WARNING!
The system must be depressurised in order
to carry out the following work . To do this,
follow the instructions in the section "Depres-
surising the appliance" .
Remove the high-pressure hose w from the
paint spray gun 7 .
Turn the handle 8 clockwise until the upper
end can be detached from the paint spray
gun 7 (see fig . B) . You can attach an adjusta-
ble spanner to the lower end of the handle to
help .
Insert the appropriate HEA filter q for the
installed nozzle 5:
white HEA filter (pre-fitted): nozzle 517
yellow HEA filter: nozzle 311
Turn the handle 8 anticlockwise back into the
thread of the paint spray gun 7 .
NOTE
Clean the HEA filters q regularly and re-
place them, if necessary . You can obtain
replacement filters from the service hotline
given in the section "Service" .
10 
GB │ IE

Use

Place the suction hose 2 and return hose 1
in the paint bucket .
Press the valve trigger z to ensure that the
valve is free of any blockages .
Insert the plug into a mains power socket .
Turn the function switch e to the vertical posi-
tion (PRIME) .
Turn the pressure regulator dial 3 to position
2 to ensure that the paint is pumped through
the system .
Wait until the paint runs through the return
hose 1 back into the paint bucket . Turn the
pressure regulator dial 3 to position 0 (off) .
NOTE
If no paint comes out, follow the measures
described in the section "Eliminating suction
problems" .
Turn the function switch e to the horizontal
position (SPRAY) .
Turn the pressure regulator dial 3 to a level
corresponding to the viscosity of the sprayed
material .
Hold the paint spray gun 7 over an empty
container .
Unlock the paint spray gun 7 by turning the
safety catch 6 so that its tip is facing down .
Pull the trigger 9 until the paint comes out in
a straight stream .
Lock the paint spray gun 7 by turning the safety
catch 6 with the tip as far back and up as
possible .
PAFS 550 A1

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis