Selecting A Spray Profile; Selecting A Jet Type; Maintenance And Cleaning; Cleaning/Replacing The Air Filter - Parkside PFS 400 A1 Betriebsanleitung

Switching on:
♦ Insert the plug into a mains power socket.
♦ To switch the appliance on, pull the trigger
and keep it pulled.
Switching off:
♦ To stop spraying, simply release the trigger
♦ When you are finished working, disconnect the
plug from the mains power supply.
Selecting a spray profile
Setting the spray volume:
♦ Turn the spray volume adjusting wheel
desired position:
(–) = minimum spray volume
(+) = maximum spray volume
NOTE
► We recommend starting at the minimum
setting.

Selecting a jet type

♦ Undo the union nut
♦ Turn the protruding parts of the nozzle head
so that they point to the desired symbol on the
spray unit .
The appliance has the following settings:
▯ round jet
vertical flat jet
horizontal flat jet
♦ Re-tighten the union nut
PFS 400 A1
to the
.
.

Maintenance and cleaning

WARNING!
Disconnect the mains plug during
breaks and while doing maintenance
work on the appliance.
CAUTION!
.
► Never immerse the paint spray gun completely
in solvent.
NOTE
► Thorough cleaning after every use is very
important for safety and operation. Oth-
erwise, the needle could get blocked and
proper operation of the appliance cannot be
guaranteed.
■ Wear suitable gloves when cleaning.
■ After every use, squirt water through the
appliance.
♦ To clean the spray unit
nozzles and the spray holes inside, use the
supplied cleaning brush
or a cloth. Never use petrol, solvents or cleans-
ers which can damage plastic.
♦ For rust protection purposes, you can spray a
little sewing machine oil through the spray gun
after cleaning.
♦ Oil all moving parts from time to time.
♦ Do not use any silicon-based lubricants.
♦ Store the appliance only in dry interior rooms.
Cleaning/replacing the air filter
Check the air filter
tions may occur.
♦ Remove the screws
♦ Remove the air filter cover
♦ Remove the air filter
contamination.
♦ If necessary, shake out the air filter
clean it under running water. Leave the air filter
to dry.
, nozzle head
, cleaning needle
regularly, otherwise malfunc-
from the air filter cover
.
and examine it for
and
GB │ IE │
19
,
.
■