Wireless Connections; Bluetooth; Bluetooth Usb Adapter; Troubleshooting - Bosch KTS 5a Serie Originalbetriebsanleitung

en | 16 | KTS 560 / 590 (KTS 5a Series) | Device description
2.5

Wireless connections

i
Users of wireless systems are responsible for
compliance with the applicable directives and
restrictions in the country concerned.
A "wireless system" in the sense of the European
Directive RED 2014/53/EU (Radio Equipment
Directive) is an electrical or electronic product
(component) that transmits and/or receives radio
waves as permitted for the purpose of wireless
communication and/or radiolocation.
WLAN and Bluetooth instructions can be found in the
separate instructions "Data protection, data security,
wireless connections".
http://mediathek.bosch-automotive.com/files/common/documents/1689/989393.pdf
These instructions must be carefully studied
prior to start-up, connection and operation of the
KTS 560 / 590 (KTS 5a Series) and must always be
observed.
2.6

Bluetooth

2.6.1

Bluetooth USB adapter

The Bluetooth USB adapter included in the
scope of delivery is inserted into the PC/laptop
and provides a radio link to components of
KTS 560 / 590 (KTS 5a Series) capable of wireless
communication.
2.6.2

Troubleshooting

i
In the event of problems with the Bluetooth radio
link, refer to the information in the separate
instruction "Bluetooth USB Adapter".
http://mediathek.bosch-automotive.com/files/bosch_wa/989/277.pdf
2.7 Information on
Bosch Connected Repair
The "Bosch Connected Repair" software (CoRe)
makes it possible to exchange customer and vehicle
information as well as protocols in the workshop.
For this, the testers (CoRe clients) are connected to
a central computer (CoRe server) via the computer
network.
Related documents:
Current overview of products supporting
Bosch Connected Repair:
http://mediathek.bosch-automotive.com/files/common/documents/1689/989386.pdf
Notes on system requirements, installation and other

information on Bosch Connected Repair:

http://mediathek.bosch-automotive.com/files/common/documents/1689/989372.pdf
|
1 689 989 223 2021-09-24
3.

Device description

3.1

Intended use

KTS 560 / 590 (KTS 5a Series) - referred to as KTS
modules in the following - are modules for controller
diagnosis. The functionality differences are shown in
the following table:
Function
Control unit diagnosis
1 channel multimeter
2 channel multimeter
2 channel oscilloscope
2 channel diagnosis oscilloscope
Bluetooth radio link
USB link
!
If the KTS 560 / 590 (KTS 5a Series) and the
supplied accessories are operated contrary to the
way specified by the manufacturer in the operating
instructions, the protection provided by the
KTS 560 / 590 (KTS 5a Series) and the supplied
accessories may be compromised.
KTS modules can perform the following functions with
ESI[tronic] 2.0:
R
Control unit diagnosis, with e.g.
$
read fault memory
$
Clearing the fault memory
$
display actual values
$
activate actuators
$
use other specific control unit functions
R
Multimeter measurements for
$
Voltage measurement
$
resistance measurement
$
Current measurement (only with special
accessory current measuring clips)
R
2-channel oscilloscope for determining
measurement values (KTS 590 only).
R
2-channel diagnosis oscilloscope for testing the
controller diagnosis interface (KTS 590 only).
KTS 560 KTS 590
x x
x x
– x
– x
– x
x x
x x
Robert Bosch GmbH