Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
All manuals and user guides at all-guides.com
5. Cleaning and maintenance operations
5.1 Generalities and products for cleaning
Before carrying out any cleaning or maintenance operations, check to make sure that the mains switch is off and
the supply plug disconnected from the mains. Accurately clean the equipment and the discs every day for a
correct operation and life of the equipment. The discs, the grid for cutting dices, and the plastic ejector, can be
removed for washing under a warm water jet. Clean the machine, and above all where the discs rest, with a cloth
or a sponge wet with warm water, accurately remove all wastes to prevent the discs from changing their position.
Open the cover and loosen the 2 pins as shown in fig.6. Remove the cover and wash under a water jet.
Clean the surfaces with water and soap, alcohol, detergents without abrasives or substances based on chlorine
or soda (chlorine water, muriatic acid). Never use abrasives, steel wool, or similar products as they may cause
damage to the paint, the coat, or the machine body. For cleaning, use non-toxic products and ones that
guarantee the best hygiene.
5.2 Operations in the case of failures
When the white pilot light on the panel is on, but the machine does not start, check to make sure that the handle
and the cover are closed. Similarly, check both safety micro switches. The safety micro switches prevent the
machine from starting whenever all securities are not activated.
In the case of failures, disconnect the main wall switch and either warn the maintenance service, or the skilled
personnel. Neither start nor tamper with the equipment personally.
5.3 Machine idle for a long time
Should the machine be idle for a long time, disconnect the main wall switch and clean the machine and its
accessories accurately. Use white Vaseline oil (or similar products) to protect all the machine's elements.
These products, mainly made up of oily and detergent substances, and now available in spray cylinders for easy
application, and besides giving a glossy aspect to the aluminium magnetism alloy, they prevent moisture and dirt
from getting inside the machine, causing its corrosion.
We advise covering the machine with a nylon (or similar) cloth.
8
www.combisteel.com
Werbung
Inhaltsverzeichnis
