Cleaning And Hygiene; Troubleshooting; Warranty - CombiSteel 7054 Serie Gebrauchsanweisung

This data is for informational purposes only.

CLEANING AND HYGIENE

1. Start cleaning your machine after you have finished with it and do the cleaning while your machine is
inoperative.
2. Always disconnect the machine from the mains before cleaning.
3. Clean the machine parts with soapy hot water and dry immediately.
4. Make sure that these parts do not remain wet.
5. Never wash the machine with pressurized water.
6. Never attempt to clean the machine while it is in operation.
7. Start the machine again after it is completely dry.

TROUBLESHOOTING

Fault
The appliance is not
operating
The appliance makes
metallic sounds

WARRANTY

7054 Series Vegetable Chopping Machines are under warranty for 1 year against manufacturing defects of
machines covering defects in the goods, hidden defects in workmanship and/or hidden defects in material.
Warranty is invalid in case of failure due to violating rules specified in operation instructions. Combisteel BV is
not responsible for any damage or loss that may occur due to operational fault.
Combisteel BV, reserves the rights to change any products without notice. Technical data, drawings, scales,
working capacities and illustrations for informative purposes only. The manufacturer shall not be liable for any
typographical errors that may occur.
Do not attempt to open the cover while your machine is running.
Switch off the power and unplug your machine before cleaning.
Never attempt to clean the machine while it is in operation.
Never wash the machine with pressurized water.
Possible cause
The plug may not be connected
The machine may be out of power supply
Foreign material may get in the machine
The machine may be damaged
Plug cable may be torn and/or there may
be lack of phase
www.combisteel.com
Actions to be taken
Connect the plug to power supply
Check the power supply
Stop the machine, cut the power
supply and check whether there is or
not foreign material
Stop the machine, cut the power
supply and check all the surfaces
Open the cable and check if there is
any fault if necessary
6