Switching On; Inserting The Battery - Stihl TSA 230 Gebrauchsanleitung

15 Switching On

1
► Push the coupling (1) on to the hose connec‐
tor (2)
► when connected to the water supply network,
open the tap
► before starting work, open the shut-off
valve (3) and allow water to flow to the abra‐
sive wheel
The water flow rate can be set via the shut-off
valve (3).
After finishing work:
► Switch off the machine
► Close the shut-off valve (3).
► Disconnect the cut-off machine from the water
supply network
Water can also be supplied via the pressurized
water tank (special accessory).
15 Switching On
When delivered, the battery is not fully charged.
It is advisable to charge the battery completely
before using it for the first time.
► Before inserting the battery, remove the bat‐
tery compartment cover if there is one; to do
this, press both safety catches at the same
time – cover is unlocked – remove the cover
15.1

Inserting the battery

1
► Insert the battery (1) into the battery compart‐
ment of the machine – battery slides into the
compartment – press gently until it clicks into
0458-707-9621-B
3
2
place – top of battery must be flush with the
top edge of the housing
15.2 Switching on the machine
2
► Unlock the machine by moving the locking
lever (2) to ‚
► Make sure you have a firm and secure stance
► Stand up straight – hold the machine in a
relaxed manner
► The abrasive cutting wheel must not touch any
objects or the ground
4
5
► Hold the machine with both hands – left hand
on the handlebar – right hand in the grip
area (3) of the rear handle
► Press the trigger switch lockout (4)
► Press and hold the trigger switch (5) – the
engine starts running
The engine only runs if the locking lever (2) is set
at ‚ and if the trigger switch lockout (4) and
trigger switch (5) are actuated at the same time.
English
3
53