Stihl TSA 230 Gebrauchsanleitung Seite 44

English
Outer diameter is smaller than the maximum cut‐
ting depth
► Make one cut from the top to the bottom
Outer diameter is greater than the maximum cut‐
ting depth
Plan first, then cut. Several cuts are needed –
correct sequence is important.
► Always start at the bottom, using the upper
quarter of the abrasive cutting wheel for cut‐
ting
► Use the upper quarter of the abrasive cutting
wheel for cutting the opposite lower side.
44
► First lateral cut on the top half of the pipe
► Second lateral cut in the marked area – never
cut into the area of the last cut, to ensure a
firm hold on the part of pipe to be cut
Only make the last top cut once all bottom and
lateral cuts have been made.
► Last cut always from the top (approx. 15 % of
the pipe circumference)
5.9 Concrete pipe – cut recess
Sequence of cuts (1 to 4) is important:
► First, cut hard-to-reach areas
5 Sample Applications
0458-707-9621-B