Space And Ventilation Requirements; Wall Spacers - Pkm GK 225.4 A+EB Bedienungsanleitung

3. The accessories of your appliance can be protected from damage due to
transportation (adhesive tapes etc.). Remove such tapes very carefully. Remove
remains of such tapes with a damp cloth using lukewarm water and a mild
detergent (see also chapter
components of the back of the appliance!
4. Install the appliance in a suitable position with an adequate distance from
sources of heat and cold.
5. Check that the appliance and the power cord are not damaged.
6. Install the appliance in a dry and well-ventilated place.
7. Do not install the appliance in a place where it may come in contact with
water/rain; otherwise the insulation of the electrical system will be damaged.
8. The door(s) must open completely and without hindrance.
9. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
10. Connect the appliance to the mains properly.
11. The rating plate is inside the appliance or at the back.

3.2 Space and ventilation requirements

Observe the required minimum distances for proper ventilation (s. chapter 3.2.1
W
ALL SPACERS

3.2.1 Wall spacers

The appliance is supplied with two plastic wall spacers
The installation of the wall spacers ensures a ventilation gap between the back
of the appliance and the wall. This allows proper ventilation as the back of the
appliance cannot be placed against the wall directly.
1. Insert the wall spacers in the corresponding openings on the back of the
appliance and tighten them.
2. Place the appliance against the wall with a minimum distance of 50 mm and a
maximum distance of 75 mm.
Depending on model
8
CLEANING AND MAINTENANCE
and chapter 3.2.2 I ).
NSTALLATION
45
). Never remove any
8