Connection Of The Water Inlet Hose - Pkm WA8-ES1415DI Bedienungsanleitung

F
G
H

2.6 Connection of the water inlet hose

 Do not use a water connection the water of which is warmer than 50 °C.
 Required water pressure (flow pressure): 100 kPa - 1000 kPa (1 - 10 bar).
 The appliance must not be connected to the mixer tap of an unpressurised water
heater.
 Check the connections for leaks by turning the tap on completely.
 If the water inlet hose is too short, replace it with a suitable length of a pressure-
resistant water inlet hose (1000 kPa/min).
 Check the water inlet hose regularly for brittleness and cracks and replace it if
necessary.
1. Ensure that the rubber washer is in the valve
connector; both ends
2. Attach the straight end of the water inlet hose to
the appropriate water connection (s. fig. on the
right).
Depending on model.
30
C
OVER
B
OTTOM OF THE APPLIANCE
 press the adhesive tape of the bottom cover firmly in place.
(s. fig. on the right).
30
of the drain pump filter
A
DJUSTABLE FOOT
~ ~
98
: