Connection Of The Water Inlet Hose - Pkm WA6-ES1015D Bedienungsanleitung

2.5 Connection of the water inlet hose

Do not use a water connection the water of which is warmer than 50
Required water pressure (flow pressure): 100 kPa - 1000 kPa (1 - 10 bar).
1. Ensure that the rubber washer is in the valve
connector; both ends
2. Attach the straight end of the water inlet hose to
the appropriate water connection; s. fig. on the
right.
3. Put the other end of the water inlet hose into a
bucket or into another suitable container (s. fig on
the right) and open the water tap to flush foreign
substances (e.g. dirt, sand, etc.) out of the water
pipe and of the hose. Check the water
temperature.
4. Ensure that the rubber washer
connector. Attach the curved end of the water
inlet hose to the inlet valve of the washing
machine; s. fig. on the right / 1. Tighten the water
inlet hose firmly (clockwise) to avoid leakage; s.
fig. on the right / 2.
Depending on model.
24
Depending on model.
25
24 / s. fig. on the right.
25 is in the valve
~ ~
83
0 C.
Fig. similar