Toshiba MMY-MUP0801HT8P-E Installationsanleitung Seite 71

System HP Conbination HP
50 24 14
52 24 14
54 20 20
56 24 20
58 24 20
60 24 24
62 24 24
64 24 20
66 24 22
68 24 24
70 24 24
72 24 24
74 24 24
76 24 24
78 24 20
80 24 24
82 24 24
84 24 24
86 24 24
88 24 24
90 24 24
92 24 24
94 24 24
96 24 24
98 24 24
100 24 24
102 24 24
104 24 24
106 24 24
108 24 24
110 24 24
112 24 24
114 24 24
116 24 24
118 24 24
120 24 24
Table 2
Liquid pipe dia. (mm)
Additional refrigerant amount per 1 m
0.025
liquid pipe (kg/m)
139-EN
IM_1141001201-2_Book.indd 70 IM_1141001201-2_Book.indd 70
Compensation by System HP (kg)
12 - - 10.1
14 - - 10.1
14 - - 10.3
12 - - 11.8
14 - - 11.8
12 - - 13.3
14 - - 13.3
20 - - 13.5
20 - - 14.5
20 - - 15.0
22 - - 16.0
24 - - 16.5
14 12 - 15.6
14 14 - 15.6
20 14 - 15.8
20 12 - 17.3
20 14 - 17.3
24 12 - 18.8
24 14 - 18.8
20 20 - 19.0
22 20 - 20.0
24 20 - 20.5
24 22 - 21.5
24 24 - 22.0
24 14 12 21.1
24 14 14 21.1
20 20 14 21.3
24 20 12 22.8
24 20 14 22.8
24 24 12 24.3
24 24 14 24.3
24 20 20 24.5
24 22 20 25.5
24 24 20 26.0
24 24 22 27.0
24 24 24 27.5
6.4 9.5 12.7 15.9 19.1 22.2
0.055 0.105 0.160 0.250 0.350
Table 3-1
Corrective amount of refrigerant varies according to indoor unit capacity rank.
Indoor unit Capacity
003 005 007 008 009 010 012 014 015 018 020 024 027 030 036 048 056 072 096
rank
Capacity code
0.3 0.6
(Equivalent to HP)
Corrective amount of
refrigerant (kg)
• If the Fresh Air Intake Indoor Unit (MMD-UP
Fresh Air Intake Indoor Unit is 0 Kg.
Table 3-2
Corrective amount of refrigerant varies for DX Coil Interface
Capacity code
8 10
(Equivalent to HP)
Corrective amount of
1.4 1.8 2.9 3.2 3.6 5.8 6.5 7.2 8.6 9.7 10.8
refrigerant (kg)
Table 3-3
Corrective amount of refrigerant varies for Hot Water Module
Indoor unit Capacity rank
Capacity code (Equivalent to HP)
Corrective amount of refrigerant (kg)
Table 3-4
Corrective amount of refrigerant varies for (MMU-UP
Indoor unit capacity rank
Capacity code (Equivalent to HP)
Corrective amount of refrigerant (kg)
Charging of refrigerant
• Keeping the valve of the outdoor unit closed, be sure to charge the liquid refrigerant into the service port at the
liquid side.
• If the specified amount of refrigerant cannot be charged, fully open the valves of the outdoor unit at liquid and
gas sides, operate the air conditioner in COOL mode, and then charge refrigerant into service port at the gas
side. In this time, choke the refrigerant slightly by operating the valve of the canister to charge liquid refrigerant.
• The liquid refrigerant may be charged suddenly, therefore be sure to charge refrigerant gradually.
Table 4
Corrective amount of refrigerant varies according to the outdoor unit diversity
Diversity D (%)
25.4
50% ≤ D < 60%
0.470
60% ≤ D < 70%
70% ≤ D < 80%
80% ≤ D < 90%
90% ≤ D < 95%
95% ≤ D
– 70 –
0.8 0.9 1 1.1 1.25 1.5 1.7 2 2.25 2.5 3 3.2
0.2 0.4
HFP ) is connected, the correction amount refrigerant for
16 18 20 32 36 40 48 54 60
024 048
2.5 5
0.2
H-E) High Efficiency 4 way cassette
009 012 015 018 024 027 030
1 1.25 1.7 2 2.5 3 3.2
0.2 0.6
Corrective amount
of refrigerant (kg)
-2.5
-2.0
-1.5
-1.0
-0.5
0
4 5 6 8 10
0.6 1.0
036 048 056
4 5 6
EN
140-EN
5/2/2564 BE 16:27 5/2/2564 BE 16:27