Checchi & Magli WOLF Bedienungs- Und Wartungsanleitung Seite 54

Lifting and transporting the work vehicle
The lifting procedure shown applies for all the work ve-
hicle models specified in the manual.
For models WOLF/1, WOLF/3, WOLF/5 the seat must be
removed to allow the lifting means to be fitted.
D
UN41 0078GF
Proceed as outlined below.
1) Use the specific tool (A) provided with the work vehi-
cle for lifting.
2) Strap up the work vehicle as shown in the figure.
3) Check that the pin (B) is secured by the lock pin (C)
and that the chains are fastened stably to the frame
(D).
Loading, transporting and unloading the work vehicle / tractor assembly
The loading / unloading of the work vehicle / tractor as-
sembly must be carried out using appropriate means of
transport equipped with suitable ramps.
Proceed as outlined below.
1) Start the tractor and lift the work vehicle as far off the
ground as is permitted.
2) Get into the means of transport from the tractor's
driving seat.
English language
SAFETY INFORMATION CONCERNING HANDLING AND
INSTALLATION
A
14
The illustration shows the work vehicle with two plant-
ing units.
4) Lift the work vehicle and place it on the means of
transport.
5) Anchor the work vehicle to the means of transport
with wedges and ropes.
6) Affix the relative signalling signs to any parts jutting
out from the means of transport.
3) Lower the work vehicle onto the truck bed.
4) Switch off the tractor engine and engage the parking
brake.
5) Anchor the work vehicle / tractor assembly to the
means of transport with wedges and ropes.
6) Affix the relative signalling signs to any parts jutting
out from the means of transport.
4
D
Use and maintenance