Operation; Connecting The Mains Power Supply; Removing/Inserting The 20 V Battery; Removing/Inserting The 12 V Battery - Parkside PLSA 20-Li A1 Originalbetriebsanleitung

Operation

The device can either be connected to the
mains power supply or optionally be ope-
rated with X 20 V TEAM or X 12 V TEAM
batteries.
Connecting the mains
power supply
1. Plug the power adapter (9) into the
socket.
2. Insert the plug (10) into the power
connection (13) on the device.
Removing/inserting the
20 V battery
1. To insert the battery (12), push the bat-
tery along the guide on the back of the
device.
You will hear it click into place.
2. To remove the battery (12) from the de-
vice, press the release buttons (11) on
the battery and pull the battery out.
Removing/inserting the
12 V battery
To operate the device with 12 V batteries,
first you will have to insert the 12 V adap-
ter.
Inserting the 12 V adapter
1. Remove the 12 V adapter (8) from
the side of the device as necessary by
pushing the latch (7) on the bottom of
the 12 V adapter away from the device
and pulling up on the 12 V adapter.
Inserting the 12 V battery
1. Slide the battery (12) into the 12 V ad-
apter (8).
Removing the 12 V battery
1. Press the release buttons (11) on the bat-
tery (12).
2. Pull the battery (12) up and out of the
12 V adapter (8).
Removing the 12 V adapter
1. Pull the latch (7) on the bottom of the
12 V adapter (8) towards you.
2. Pull the 12 V adapter up and out.
3. For storage, you can slide the 12 V ad-
apter (8) onto the guide (14) on the side
of the device.

Switching on/off

1. To switch the device on, press the
On/Off switch (2). The LED lamp illumi-
nates with maximum brightness.
2. To switch the device off, press the
On/Off switch (2).
Changing the
illumination mode
When you switch the device on, the LED
lamp illuminates with maximum brightness.
Switch the illumination mode by pressing
the switch (1) next to the On/Off switch (2).
The repeating order of modes is: 2000
lm - 1000 lm - flashing
GB IE
19