Operation; Connecting The Mains Power Supply; Removing/Inserting The 20 V Battery; Removing/Inserting The 12 V Battery - Parkside PLSA 20-Li A1 Originalbetriebsanleitung

from the mains before cleaning
the charger.
• Do not subject the battery to
strong sunlight over long periods
and do not leave it on a heater.
Heat damages the battery and
there is a risk of explosion.
• Allow a hot battery to cool be-
fore charging.
• Do not open up the battery and
avoid mechanical damage to
the battery. Risk of short circuit
and fumes may be emitted that
irritate the respiratory tract. En-
sure fresh air and seek medical
assistance.
• Do not use non-rechargeable
batteries!
• Do not use any accessories that
are not recommended by PARK-
SIDE. This can result in electric
shock or fire.
Observe the safety informati-
on and notes on charging
and proper use as shown in
the instruction manual for your
battery and charger from the
X 20 V TEAM or X 12 V TEAM se-
ries.
A detailed description of the char-
ging process and further informa-
tion can be found in the separate
operating instructions.

Operation

The device can either be connected to the
mains power supply or optionally be ope-
rated with X 20 V Team or X 12 V Team
batteries.
Connecting the mains
power supply
Only operate the light with
mains power with the enc-
losed power adapter
JLH341801500G.
Only use indoors.
1. Plug the power adapter (9) into the socket.
2. Insert the plug (10) into the power
connection (13) on the device.
Removing/inserting the
20 V battery
1. To insert the battery (12), push the bat-
tery along the guide on the back of the
device. You will hear it click into place.
2. To remove the battery (12) from the de-
vice, press the release buttons (11) on
the battery and pull the battery out.
Removing/inserting the
12 V battery
To operate the device with 12 V batteries,
first you will have to insert the 12 V adapter.
Inserting the 12 V adapter
1. Remove the 12 V adapter (8) from
the side of the device as necessary by
pushing the latch (7) on the bottom of
the 12 V adapter away from the device
and pulling up on the 12 V adapter.
Inserting the 12 V battery
1. Slide the battery (12) into the 12 V
adapter (8).
GB
21