Positioning The Product; Operation; Charging The Battery; Switching The Product Off - Parkside PAS 2800 A1 Bedienungs- Und Sicherheitshinweise

z Positioning the product
You can adjust the position of the product
vertically and horizontally�
Using the handle
„ „ 2
a flat, even surface. Make sure that the
stand is stable� Protect easily damaged
surfaces before setting up the product�
First, unfold the LED panels
„ „
and right (see fig. C). The LED module
is now visible�
The LED panels
„ „
3
vertically to any angle�
Loosen the hinge screws
„ „
LED module horizontally (see fig. E).
4
Once the desired position has been
„ „
achieved, refasten the hinge screws�
z Operation
Please note: Only operate the product if it
is on a suitable surface�
The product can be operated in different
modes� These can be selected by pressing
the ON/OFF button
Start by positioning the product (see
„ „
chapter titled "Positioning the product")�
Press the ON/OFF button
„ „
switch between modes:
Press 1 x - 100%
Press 2 x - 50%
Press 3 x - Off
z Charging the battery
Press the button to check the charge level of
„ „
the battery (see Fig� D)�
9
The charge indicator
„ „
indicates the charge status of the
rechargeable batteries: 25% - 50% - 75%
- 100%. The first LED will start flashing
when the battery charge is low�
, place the product on
to the left
3
4
can be aligned
to align the
7
(see Fig� D)�
11
as follows to
11
(see Fig� D)
8
Please note: The product cannot be
switched on during the charge process� It
is, therefore, not suitable for continuous
operation�
RISK OF ELECTRIC SHOCK! Only
charge the product in dry, interior
rooms, as the splash water
protection (IPX4) cannot be guaranteed
when the charging cable is connected�
Do not carry the product during charging�
„
Open the USB cover
„ „
charging socket
12
the USB-C charging cable provided
fig A) into the USB-C charging socket of the
product�
To charge the battery, connect the USB-C
„ „
charging cable
6
(SELV - 5 V, max� 1 A, not included)�
Plug the USB mains adaptor into a power
„ „
outlet�
All LEDs in the charge indicator
„ „
start flashing. The battery will start
charging� The more LEDs light up
continuously, the higher the charge status of
the battery�
When the product is fully charged, all of
„ „
the LEDs will remain constantly on�
You can now unplug the USB mains
„ „
adaptor from the socket and the charging
cable from the product�
Place the USB cover
„ „
again to protect the product from humidity
and ensure splash water protection�
z Switching the product off
Press the ON/OFF switch
„ „
product off�
Alternatively, you can fold the LED panels
„ „
inwards�
3
of the USB
10
(see fig. D) and plug
(see
6
to a USB mains adaptor
will
8
over the jack
10
to switch the
11
GB/IE/NI
9